Record widths, heights and both diagonals
Measure across the opening near the top, centre and bottom, using corresponding faces at each point. Take height readings on the left and right from the same type of bottom reference. If the corners are accessible, measure diagonally between opposite corners both ways. Note whether you measured a rough opening, the inside of an installed frame or the slab. The readings only compare well when they describe the same part.
Take a photo of the whole opening before sending closeups of the corners or areas where the door binds. If the frame is still in place, look for uneven gaps when the leaf is closed. State whether the reading reflects the visible frame or framing behind the trim.
Send the readings as a range
Keep both diagonal readings and the different widths and heights. Do not average them into one size or subtract a guessed allowance. A new slab or frame may need work at the opening even if a single dimension seems to match. Ask an installer to verify the structure, floor level and fit before ordering.
- Describe where the existing door rubs, sticks or leaves a gap.
- Mark any measuring points that were inaccessible or only approximate.