Measure the moving panel
Open the door and measure from one edge of the leaf to the other. Leave the frame, stops and casing out of that number. Check the width near the top, middle and bottom. For height, measure from the slab's top edge to its bottom edge along each side. If the bottom edge is hidden by a sweep, note whether the sweep was included rather than guessing where the material ends.
Measure thickness at an exposed edge away from the hardware. If one edge is beveled, make a note of which edge and which face you measured. Keep measurements as written on the tape. An uneven old door can look like a standard size after rounding.
Record what a matching slab needs
If the existing frame is staying, the next check is where the hinges and latch meet it. A slab of the same width and height can still need a different hinge layout or lock preparation. Check whether the listing shows a bare slab, a slab prepared for hardware or an assembled unit before requesting it.
- Write width x height x thickness, followed by the unit of measure.
- Include photographs of the hinge edge, latch edge and bottom sweep when those details have to match.