CHEAP
DOORS.

How to check door lockset backset

Backset is the distance from the door edge to the centre of the main lock bore. It helps match the door preparation to the lock you plan to use.

Measure the existing hardware layout

With the door open and safely held, identify the centre of the main bore on the leaf and the edge where the latch comes out. Measure from that edge to the centre. If the handle trim covers the bore and the centre can only be estimated, note that uncertainty rather than guessing an exact size. Record the slab thickness as well, since the lock may need a compatible thickness.

If there is a separate deadbolt, note the gap between the bore centres as a different measurement. Record the edge latch or deadbolt position and take pictures of the strike plates in the frame. A photo showing the full handle and deadbolt layout helps distinguish separate holes from a single combined lock setup.

Ask what comes drilled

Find out whether the proposed leaf is blank or comes with holes. Compare the actual bore and backset requirements for your hardware with the supplied door preparation. If you intend to keep the frame, ask whether the latch and deadbolt positions will meet the existing strikes.

  • Use a separate line for the handle and deadbolt dimensions.
  • Share the hardware model if known and confirm which parts are staying.