CHEAP
DOORS.

Match the Hinges on a Replacement Door Slab

Measure each hinge cut from the same end of the slab. A handful of good measurements can tell you whether a factory-prepped replacement will hang in the old jamb.

Use one starting point for every hinge

Open the old slab and photograph its hinge edge. Measure from the top of the slab to the top of every hinge recess and record the numbers in order. Then measure the length and width of the hinge leaf and its recess depth. Note whether the corners are square or rounded. Using the top for every measurement helps avoid adding together several small errors.

Check thickness, bevel and fastenings

Measure the slab thickness on the hinge side and inspect the shape of both vertical edges. A bevel can give a swinging leaf clearance at the latch as it closes. Look for loose screw holes or chipped recesses on the frame side if you plan to reuse it. Ask whether the replacement leaf has a compatible edge and which drilling or cutting the manufacturer allows.

Choose factory prep or a blank on purpose

Lay a tape next to the hinge cuts in a clear photo and label the top. Share that photo with the actual measurements. If the factory hinge layout differs, determine whether a blank can be fitted to the existing frame. Note if a lock bore is needed as part of the work.